

Updating GDO Security+ 2.0 MyQ Door Control Push Button for use with OP2/Elk panels
Posted by
pete_c
,
04 February 2019
·
2278 views
Hardware required:
1 - Security+ 2.0 MyQ Door Control Push Button $10 on Amazon.
2 - some spare thin wire (22/2 alarm wire is good to use)
Skills:
Soldering wires to traces on the door control board.
Connect the control push button to your GDO via two wires. Program it to open your garage door and disconnect it from you GDO.
Open the little control push button and solder two wires to traces shown in the picture.
Use these two new wires to connect to your Omni Pro or Elk Panel relay for the GDO.
1 - Security+ 2.0 MyQ Door Control Push Button $10 on Amazon.
2 - some spare thin wire (22/2 alarm wire is good to use)
Skills:
Soldering wires to traces on the door control board.
Connect the control push button to your GDO via two wires. Program it to open your garage door and disconnect it from you GDO.
Open the little control push button and solder two wires to traces shown in the picture.
Use these two new wires to connect to your Omni Pro or Elk Panel relay for the GDO.