Jump to content


TonyNo's Blog



Photo

3D Printer Build

Posted by TonyNo , 29 March 2013 · 1535 views

I finally decided on a 3D printer design and I'm going with the Prusa i3 . I was going to buy an existing kit, but, found that I could save ~$400 by sourcing everything myself. Let's see if that pans out. :lol:  The i3 is essentially a combination of a Mendel  and a Wallace . Of course, I start down this road and then find a design that I like b...


Photo

Weekend Work

Posted by TonyNo , 14 December 2008 · 440 views

So, with the warm temps here (46F!), I decided to at least put up my icicle lights. On one of my four strings, only half were on. Turns out it was bad LED's. Not blown out, of course, but corroded!

Posted Image

These were Philips strings purchased from Target maybe two years ago....


Photo

Monday

Posted by TonyNo , 08 December 2008 · 415 views

Ugh. Mondays.





April 2017

S M T W T F S
      1
2345678
9101112131415
16171819202122
23242526272829
30       

Recent Entries

Recent Comments