Elk m1, announce specific user RFID

I have the Elk RFID devices installed and working as they should. Now is there a way to program a rule to announce the user when a card is used?
Like "Clay is home" etc...
 
It seems there should be a way to access the text for a rule, but I am not seeing it.

Custom text, but you're going to be limited to (I want to say) 10? on the normal M1 and each is going to eat a rule in addition to you recording the message if the text doesn't fit.

DELInstallations said:

Custom text, but you're going to be limited to (I want to say) 10? on the normal M1 and each is going to eat a rule in addition to you recording the message if the text doesn't fit.

Click to expand...

Thanks!
EDIT: Never mind this> Do I have to record the text or can the system speak phonetically? 
 
I am assuming I would use one of the miscellaneous messages, like VM239....to send the output to the speaker, but I can't figure out how to retrieve the RFID info.

RFID is based off of user code/position, so you work it off the disarmed status then add the conditional "and" with the user.

The custom word would need to be recorded, usually via a phone interface, all in the rear section of the manual.