Rules not working on 2.0.20?

starmanj

New Member
I used to get the ELK to turn on an Insteon light when the DSC motion sensor was triggered.  It now will occasionally turn the light on but not off.  
 
I'm trying to debug the Rules-- and now notice I can't get the DSC motion sensor to trigger a voice response (maybe that part never worked, not sure).
 
My M1G is at h/w .13, boot 3.3.6, f/w 5.3.0, voice list .8.
 
My ISY and Elk M1G are both using fixed IP addresses.
 
Has anyone noticed this?  Any ideas why the ELK no longer works with Insteon?
 
 
 
I got the voice response working; they all have to be enabled under "Global Options".  Then they work when testing under Rules.
 
But the ELK still won't reliably operate any Insteon equipment...
 
You might want to try rolling back the firmware. I started having some unexpected results after recently upgrading. Just rolled back last night so a bit early to pronounce the issues resolved. However they initially came to light after upgrading.
 
A good debug method is to perform another action, e.g. beep keypad or if you have an output board, trigger an output to watch the LED.  Also watch for rules that trigger each other one after another - they run in order and if you make a state change it may cause a future rule to trigger.
 
Note that Voice messages are affected by the Global Voice settings, e.g. if you disable system messages, even rules that attempt to speak will be overridden.
 
Back
Top