HAI programming for Sounder chirp

I have an HAI omnipro II and am trying to setup a notification chirp.  Is there a way to program the Horn or sounder to chirp?  I would like to be able to have the horn chirp in much the same way as the console (door opening or closing).  This way I know if someone comes in the front door when I am in the basement. The console is not loud enough to be heard throughout the house.
 
Thanks

I have utilized the keypad / Omnitouch sounders for that one if by land two if by sea replacing the text to speech stuff.
 
That said I do have consoles all over the house.  I have not tried this with the external / internal sounders.  I do though sometimers hear them chirp when turning on or off the alarm.
 
After 3 beeps I was considering some morse code stuff but it got a bit low on the WAF.
 
Easy to do with PCA.

You can't manually control the siren outputs, even though they show up in the list of outputs in PCAccess.
When you try the system goes into a loop and you have to reboot it.
 
You could wire one of the other outputs in parallel to the alarm sounders and operate them manually to chirp the siren(s).
You may want to isolate it through a relay..