Setting Digital I/O

Hello,
 
I'm new at setting up and using the Web Control Board.
 
I'm interfacing it with the ISY-994
 
I have them where they will pass data both directions, that is the ISY will control the outputs one at a time and WC* will send temperature to the ISY.
 
My question: Is there an 8 bit word that can be read / written that will show the status / set the outputs all at one time ?
 
Thanks
 

Yes,  If you have the latest board with 3.03.19 rev firmware, or 2.2.2 board with 3.02.17a or later firmware, you can get all the TTL input value and TTL output values at
ALLINS
and
ALLOUTS
 
ALLINS is read only, ALLOUTS can be read and write.
They are  listed on the 3.03.19 version firmware user guide page 35.  Thanks.

CAI_Support said:

Yes,  If you have the latest board with 3.03.19 rev firmware, or 2.2.2 board with 3.02.17a or later firmware, you can get all the TTL input value and TTL output values at
ALLINS
and
ALLOUTS
 
ALLINS is read only, ALLOUTS can be read and write.
They are  listed on the 3.03.19 version firmware user guide page 35.  Thanks.

Click to expand...

*****
TERRIFIC, thank you very much !
Don