ELK M1 Gold Clock has Died?

Have an M1G that is about 13 years old.  The system is still working fine, but the clock has stopped working (0/0/2000 12:00 AM).  Have tried all of the troubleshooting tips I could find on this forum;
- Replaced CR2032 battery
- Replaced back-up batteries
- System restarts.
 
Any other suggestions?

Check your time server settings in Elk RP2 software.
 
Mike.

I was not using a time server.  Is there a setting that would not allow the clock to be set?

Did this happen with the switch out of DST?  Elk firmware has had issues with that.  Though not just going to the old blinking 12:00, but still.  I'm not able to check my current firmware, but it is working very well.  Anyway, you might consider upgrading your firmware.

I'll give it a try.

Have you looked at the Sunrise/Sunset setting in ElkRp2 settings? It is under automation>Sunrise/Sunset
 
Mike.