From HAI wedsite; "This chip is used to upgrade the firmware for non-flash enabled (before 02/08) OmniPro II controllers".
Since you were able to upgrade through PC Access, you don't need the chip.
The SHR-708x and 808x series DVR's by Samsung (GVI Security) also have hdmi (1080p) output .
http://www.samsung-security.com/products/v...rders/index.php
I had similar problem while trying to install the MCS on a Window Vista machine. I get a message that it requires "Microsoft Visual C++ Runtime 8 (includes ATL and MFC) Service Pack 1(x64) before setup can continue. On an XP Pro machine, I get similar message but the installer downloaded the MS...
I don't own music port yet and therefore have not followed the progression of the software versions. The version 2.0.4945.0 this is currently available on the prozone when installed, shows up as version V2.1.5054.65. It also includes a tab "online credentials" (I don't know if this tab is also...
It is located in the new prozone. You will need a new user id and password. I don't own the music port yet. It is on its way but, I downloaded and installed the software and it shows the version I posted above. The digital timestamp on the software is Friday Oct 23, 12:50pm. The direct link...
There is a new version of the MP software V2.1.5054.65 on the Prozone. Nuvo tech support indicated it was posted today. It includes Pandora and XM support.
I will be interested in how this unit works out. It could be a good (may be low cost) alternative to cat5 balums with power. The left port in the picture is signal and the right port is signal+dc. Essentially, one would need two of these units and a power supply for each camera.
Great video tutorial. I watched the first 4 and they are lot easier to grasp than the written tutorial and also detailed. Thanks Dean. Keep them coming.
I too downloaded the software and I having problem getting it to control x10 lights. I loaded the smarthome 1132u driver and could connect to it. When I go to the client driver and click add, I see the 1132u driver and can load it. I am then presented with the x10 configure page that shows house...
You can handle it. Connect the 4 video sources (cameras) to the inputs and assign an ip address to the server. An easy way to assign the ip address is to use the AXIS IP UTILITY found here
Next, type the assigned ip address into the web browser (http://ip address) to access the server. Once...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.