Ok, thanks for the tip on using a snubber diode. Video does help but still a little confused about having to select a zone or zone type? I just want trigger 17 on when armed.
I am trying to figure out the programming for fields *79 and *80 to have the output trigger only go on when I am armed away (it is for a relay that shuts my water off). Hoping someone can list the steps for fields 79 & 80 to make this happen. It would have to stay triggered all the time when...
I believe they are 2200ohm, is that my problem for both the 4-wire & 2-wire smoke detectors? I now do see in the instructions that 2-wire smokes should use 820ohms, but shows 4-wire smokes require 2200ohm?
I have 2 fire zones set up using System Sensor i3 series photoelectric smoke sensors. One zone is using two sensors in series (models 2WB) as a 2-wire zone with one 2.2kOhm EOL resistor. Other zone is one sensor (model 4WB) using as a 4-wire zone, also with one 2.2kOhm EOL resistor. Whenever I...
I ran out of hardwired zones on my ELK M1 and am wondering if I can add an identical second 4-wire motion sensor onto the same zone as an exiting one? Thank you.
I had the same problem today. Ended up that the MAC address of the M1XEP changed! An the new default IP was 192.168.3.??? which is not the standard default 192.168.0.251. Very strange but first thing to try is find the XEP in ElkRP software and go from there.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.