Search results

  1. G

    ALC Lights not working from OmniTouch

    I just read somewhere that someone had problems with there ALC switches several times and it was because of "events" that "took out the low voltage side of the switches". That could possibly be what happened. If that is the case, I am wondering what might be a good replacement for these lights...
  2. G

    ALC Lights not working from OmniTouch

    I have an OmniPro II with about 5 ALC Lights on it covering the outside perimeter of my house. They all work fine from the switches, but do not work from the controller (Touch pads, iPhone, iPad, PCAccess). I thought it was a "no brainer" and got a new ALC board. Installed that and same thing...
  3. G

    ALC Lights not working from OmniTouch

    I have an OmniPro II with about 5 ALC Lights on them covering the outside perimeter of my house. They all work fine from the switches, but do not work from the controller (Touch pads, iPhone, iPad, PCAccess). I thought it was a "no brainer" and got a new ALC board. Installed that and same...
  4. G

    Temporarily disable, or bypass, a motion detector.

    Have tried doing this several times but unsuccessful, in programming my OmniPro II. I have fans and lights that operate according to room occupancy. However, I am trying to over-ride the motion to shut a fan or light off temporarily. I am including lines: WHEN lrflag ON THEN BYPASS ZONE living...
View older results
Back
Top