Search results

Thanks, That is what I was looking for :)

I have been designing a complete 6 zone sprinkler system around my Elk M1-G using a Relay expansion card remotely mounted in garage. :) Today I started looking at rules to use for same and promptly hit a snag trying to develop a rule that will allow watering on odd days only, as required by the...

I have attached a pdf file with specs for Modular Cable Wiring. The section dealing with ISDN or POTS (Public Operated Telephone System) interface cable is what you need. I have a network cable tester and went through a number of the cables that I have accumulated over the years.\ until I found...

1. Are you using an X10 PSC05 interface that is not included with M1G but has to be purchased separately? 2. If you have PSC05, are you using a standard 4-wire phone cable between it and the M1G jack? I just went through this and wasted a lot of time, and hair, :) because the diagram in the...

Hey Guy: I picked up a Lantronix MSS100 on Ebay recently to do the exact same thing you are doing but havn't had time to play with it much yet. I did get it working and flashed the software with latest upgrade but I had been digging through the documentation trying to figure out which port to...

I was browsing the forum and saw your post. I just added a RF expander to my M1-G and had almost similar experience as yours the first time after the expander was enrolled. ie..It was changed to a Wired Zone by RP. I did exactly the same thing you did, starting my wireless zones at 65, while my...

:) Is there, or will there be any way to enroll the GE wireless devices using RP software similar to kepad process? I just went rhrough this with a couple of 4 button keyfobs and it sure would be nice to sit in front of your computer and add them!!

:) I am sure others have done this and my problem is likely old hat but I recently switched from GE Simon to Elk M1-Gold in the process of building a new home. I had forgotten what I set the GE system up to dial when using the Linksys ABN that Nextalarm provided and initially set the Elk M1 to...

Duplicate post, Sorry

YES!!! (1) I created a new user code without the zero and it worked perfectly. (2) I then downloaded and flashed the keypad with 1.0.8 and the original code now works also.... Thanks again Don. I reviewed the downloads last week but apparently missed the PAS update. Now if I can just get the...

I checked JP2 yesterday and it is set for 2-way. The user code is enabled for disarm and it works fine for both arm & disarm on the M1KP primary keypad. Thanks Don

I re-enrolled the bus devices again with RP software and the PAS shows up as Keypad 5 and the details screen for enrolled keypads and expanders shows the following for same: Keypad=5 Firmware=1.0.6 Hardware= 2.4 Bootware=1.0.4 Another...

Thanks for the reply. I have done the following: 1. I re-enrolled the keypad twice and even changed the address on it to device 5 just to be sure it was working. 2. See 1 above. 3. I am using home run Cat5 cables to both keypads and also including a Zone Expander in the chain. (a)The Zone...

I am in the process of installing my M1G and have added a second M1KPAS arming station for the back door which appers to work fine until I attempt to disarm the system with a user code then it acts as if the system is ignoring it. It works fine for arming using the same code and all indicators...