"No Module Found in Setup" Error

[rs691919]

Three of my lights stopped responding to commands from the Omni Pro board. LEDs are blue on all three. I tried reconfiguring using both the keypad and PC Access, but an error pops up saying No Module Found in Setup. The rest of the units in the house are working fine, just these three (which happen to all be in the same room). Any ideas?

 

[pete_c]

Noise maybe if X10 or UPB.

Have you tested the light modules (switches)?

 

[rs691919]

Not sure what you mean by testing them...can you elaborate please? Thanks for replying!

 

[pete_c]

What type of light modules do you have? You will have a controller plugged in to the HAI panel for the type of light modules you are using.

 

[rs691919]

As far as I know, they're the HAI HLC lighting controls.

 

[pete_c]

HAI HLC lighting is UPB.

From PCS:

All HLC products use Generation II Universal Powerline Bus (UPB™) – a digital communications standard for lighting and home control that ensures superior reliability. UPB™ has been extensively tested and researched in residential environments and found to be 99.9 percent reliable. UPB™ works over existing wires in a home and does not require new wiring.

You can test the HLC lighting with a UPB controller and UPB Upstart running on a Windows PC.

As mentioned earlier it might be noise or defective HLC switches. If in one room it may just be noise.