• You've been granted Beta access to this site, allowing you to explore some of the new features while they're still under construction. More information can be found in the Beta forum.

Omni Pro 2 12v Smoke detectors NOT READY

stukinc

New Member
Hi All,
 
I recently had my OP2 controller fail as I was updating it and everything defaulted.  I could not ping it, and ended up sending it to Leviton for repair. I got it back and everything is working with one exception.  I've had the system about ten years, but for some reason zone 1 & zone 2 where I have my smoke detectors wired is NOT READY.  I'm thinking it must be defaulted to NO and I need it to be NC?  Does it default to NO?  As I mentioned, I have had the system installed for years, but i don't remember having to do anything different with the smokes when I installed.
 
I'm hoping for some direction on how I can program this in PCA on zone 1 & zone 2.  
 
Thanks in advance for any help.
 
 
 

Radcliff

New Member
Hi All,

I recently had my OP2 controller fail as I was updating it and everything defaulted. I could not ping it, and ended up sending it to Leviton for repair. I got it back and everything is working with one exception. I've had the system about ten years, but for some reason zone 1 & zone 2 where I have my smoke detectors wired is NOT READY. I'm thinking it must be defaulted to NO and I need it to be NC? Does it default to NO? As I mentioned, I have had the system installed for years, but i don't remember having to do anything different with the smokes when I installed.

I'm hoping for some direction on how I can program this in PCA on zone 1 & zone 2.

Thanks in advance for any help.
Did you find anserwer?
Hi All,

I recently had my OP2 controller fail as I was updating it and everything defaulted. I could not ping it, and ended up sending it to Leviton for repair. I got it back and everything is working with one exception. I've had the system about ten years, but for some reason zone 1 & zone 2 where I have my smoke detectors wired is NOT READY. I'm thinking it must be defaulted to NO and I need it to be NC? Does it default to NO? As I mentioned, I have had the system installed for years, but i don't remember having to do anything different with the smokes when I installed.

I'm hoping for some direction on how I can program this in PCA on zone 1 & zone 2.

Thanks in advance for any help.
I have same issue. How did yours get fixed? Thanks
 

dwalt

Active Member
Hello Radcliff,
Please provide some more detail. Were the smokes working properly and just quit? Have the jumpers been set to "smk" on zones 1 and 2?
Do you use PC Access software? If so, it would help to get more info..
Dwalt
 
Top