Power for hard wired PIR

[EENut]

Where is the porper place to power your hard wired PIr on a Elk M1G. Pir required 12 volts to power it.

 

[BraveSirRobbin]

From page 5 of the Elk's manual, use VAUX and NEG terminals. I highly suggest using an Elk Power Distribution Module if you have multiple sensors that require 12 volt power distribution.

 

[EENut]

From page 5 of the Elk's manual, use VAUX and NEG terminals. I highly suggest using an Elk Power Distribution Module if you have multiple sensors that require 12 volt power distribution.

Thank you.