How would I program scenes into my elk zwave module using the Z-troller. The z-troller requires that it be the primary controller and it does not support setting up scenes or groups. I've been using my ZTH100 controller to do it up to this point.
Would I do it in steps?
Ztroller master setup -> ZTH Scene setup -> Elk?
If you have to setup the scenes in homeseer that seems like it would be a pain. I got the ztroller so that I could use Z-seer, a zwave network diagnostic and optimization program.
ideas?
Would I do it in steps?
Ztroller master setup -> ZTH Scene setup -> Elk?
If you have to setup the scenes in homeseer that seems like it would be a pain. I got the ztroller so that I could use Z-seer, a zwave network diagnostic and optimization program.
ideas?
