pete_c
Guru
Here I have my outdoor HV UPB lighting controlled by the OPII panel.
The bits of programming I have are related to:
1 - scheduled night lighting with a dim down to 25%
2 - alarm event lighting relating to motion after hours at 100%
I have night day sensors on all of my outdoor combo cameras (Optex) but have never used or connected this part of the camera.
Can I add some new programming lines that would turn on the lights at 100% during a foggy day or very overcast day using the NO night dark switches in the combo cameras. Ideally maybe polling more than one camera?
Would this be better as a separate set of programming lines?
something like:
1 - time is after sunset and before sheduled on time (25%)
2 - check light dark NO switches (put more than one here) to see if they are closed (using more than one)
3 - turn on outdoor lighting at 100% until light dar switches go back to NO
The bits of programming I have are related to:
1 - scheduled night lighting with a dim down to 25%
2 - alarm event lighting relating to motion after hours at 100%
I have night day sensors on all of my outdoor combo cameras (Optex) but have never used or connected this part of the camera.
Can I add some new programming lines that would turn on the lights at 100% during a foggy day or very overcast day using the NO night dark switches in the combo cameras. Ideally maybe polling more than one camera?
Would this be better as a separate set of programming lines?
something like:
1 - time is after sunset and before sheduled on time (25%)
2 - check light dark NO switches (put more than one here) to see if they are closed (using more than one)
3 - turn on outdoor lighting at 100% until light dar switches go back to NO
