Hi all,
i have WC8 board with 3.02.17g firmware that i tried to upgrade following the guide and downloading files from site.
I launched bootloader through browser (and board stopped running PLC code), and started blinking LEDs as requested.
At half of uploading new firmware stopped blinking,PC gave an error and board stopped answering to any signal.
Now at old IP the board doesn't reply (nor PING neither HTTP), and even to the default one.
Should i try to reset the board?
Is there any recovery procedure?
i have programmers and so on, please help me ASAP.
Thanks in advance,
GM
P.S. This is the third board i bought, the first and the second had old "not upgradable" firmware but shipping the old one to the U.S. was more expensive that buy another one.
Now my PLC code cannot run into the old one so i cannot temporarily solve in that way...
i have WC8 board with 3.02.17g firmware that i tried to upgrade following the guide and downloading files from site.
I launched bootloader through browser (and board stopped running PLC code), and started blinking LEDs as requested.
At half of uploading new firmware stopped blinking,PC gave an error and board stopped answering to any signal.
Now at old IP the board doesn't reply (nor PING neither HTTP), and even to the default one.
Should i try to reset the board?
Is there any recovery procedure?
i have programmers and so on, please help me ASAP.
Thanks in advance,
GM
P.S. This is the third board i bought, the first and the second had old "not upgradable" firmware but shipping the old one to the U.S. was more expensive that buy another one.
Now my PLC code cannot run into the old one so i cannot temporarily solve in that way...