Elk and isy994i Question?..

I have five gri2600 water leak sensors connected to zone 10,11,12,13 and 14 ,air want to be able to write rules in my isy console,like this: if zone 10 ( gri2600 detector) is not secure,Then speak,water leak detected under kitchen sink,problem is zone 10 to 16 does not show up in the isy console,please help. Thanks.

I've never used an ISY, so I don't have anything to add there...
 
Just curious: Since those are wired to Elk inputs, why not just write those rules in Elk natively?

:hesaid: No need to involve the ISY. The KISS principal applies here.

Sorry, I am learning this stuff, so I need a little spoon feed , I just need to understand the basic and learn the rest

Have you connected ElkRP to your Elk panel?

Also, do you have the Elk module for your ISY? It is needed for the ISY and Elk to communicate with each other. 

Yes I do have my isy, elk and the (elk module)elk Ethernet module all connected to my network and working very well,just that in my isy console it shows the first eight zones and not the other eight.Thanks

I fine it rather odd that the first 8 zones show on the ISY console, and the second 8 (zones 9-16) don't. Have you asked about this on the Universal Devices forum? The admins there will stick with you until your issue is resolved.
 
http://forum.universal-devices.com/

I use zones above #8 on my Elk with ISY. Something is wrong in settings. As suggested, log into the UDI forum and post request AFTER double checking settings. I suspect this is a setting in the Elk, not ISY.