What serial port type for Leviton Power Hub 83A00-1

kwschumm · Apr 20, 2018

Thanks to StarTrekDoors for the tip about using the Leviton Power Hub to offload power from an OmniPro II.

I've read the 83A00-1 manual, and the OmniPro II manual, and have not found how the OPII serial port should be set up when this hub is connected.

Should the serial port be set to type 3 for Omni-Link? If not, what should it be set to?

TIA

StarTrekDoors · Apr 27, 2018

You don't have to connect the serial port if you don't use it. Serial is for card readers and similar. Controller on the power hub is connected directly to the console A/B connections on the Omni when using consoles.

WARNING: Read closely about SW1 because you need to set it appropriately depending on the devices you connect to the hub to avoid damaging your Omni.

kwschumm · Apr 27, 2018

StarTrekDoors said:
You don't have to connect the serial port if you don't use it. Serial is for card readers and similar. Controller on the power hub is connected directly to the console A/B connections on the Omni when using consoles.

WARNING: Read closely about SW1 because you need to set it appropriately depending on the devices you connect to the hub to avoid damaging your Omni.

So you're saying that for only console connections (not Touchscreen) only the A/B connection is needed? That makes it easy. Thanks!

What serial port type for Leviton Power Hub 83A00-1

kwschumm

Active Member

StarTrekDoors

Active Member

kwschumm

Active Member

Similar threads