Recent content by adsbar

Addendum: Too Much Traffic!   I think I have solved a majority of my problem.  In looking through the configuration of the I/O module in Upstart, I saw under the "Advanced" tab the following options: Transmit Type and Transmission Attempts.  Transmit type is Link Packet, which seems OK.  For...

I went back to Upstart to see if I can configure it the way you described.  However, the input side and output side are completely disconnected, and work differently.   The outputs, called Receive Channel 1 and Receive Channel 2, appear only to respond to Link Activate Commands.  There is no...

Recently, the switch for my RF fireplace remote burned out, and I decided to finally use the SA UMI-32 I/O module I had lying around.  The setup is as follows:   There is a wall switch with wires to the fireplace, previously unused, which I connect to to Input #2, terminals 9&10 on the I/O...

On the touchscreens, my panel has the same IP address - I had made this static on my router. The Web-link server software still shows the same IP address as well. Snaplink (android) is using the dynamic DNS address, proving that the DynDNS service is working, and that port forwarding on the...

Hope someone can shed a little light... I have had an HAI Omnipro II with Web-link software for several years. I have the Web-link server running on my Windows Home server. I have also purchased the Snaplink for Android application. Everything was running fine until last week. Currently...

That's a little concerning. I am planning to build a 5000+ sqft home, and this is the first I've heard about UPB switches being "slow". Can anyone with some hands-on experience tell me if there is any noticable latentcy in UPB commands? Does this only apply to scene lighting, or is it...