Recent content by Ampcom

The app developer got back to me. His response is as follows:-   “I am sorry. This is a behaviour we are seeing in some installs. Some devices are able to automatically recover the configuration data, but some are not. It is hard to explain why but it appears to be a side effect of the issue...

Yes, I am the same. Lost config settings and even after re-configuring, does not save. I followed procedure as per message at the end of config, which says do not force close, but still does not save or work. I am now getting calls from many customers about this. I am based in Australia...

Cheers Mike,   We only have the "M" version here in Australia.

F Button LED feedback should occur in approx 250-500 milliseconds. If it's really slow and you have confirmed the sensor feedback is triggering quickly (you could write a voice rule to hear the annunciation compared to the feedback on the F button).   Data Bus resistance issues is a likely...

If your keypad volume is set to 0 (zero), and chime is set to "Tone" only, you won't hear the "beep beep" when the zone is triggered.   Cheers, Philip

Hello,   I upgraded to v2.0.36 on the 22nd Dec 2017. Since then have connected to several panels, including remotely and have experienced no problems.   The release notes explain what the update included:-   Dec 18, 2017 - ElkRP2 Software Release 2.0.36 1. ELK-M1XRFTWM Wireless Receiver - ElkRP...

Hello everyone,   Thank you very much for all your responses. They have been great and very helpful. I am leaning towards an interface that does not have to have a PC running 24/7 which I believe CQC requires. So I may leave CQC out of the options on this instance.   Cheers, Philip

By the way DELInstallations, the connection between NESS M1 / Elk is that NESS over here in Australia are electronics manufacturers and were the original and exclusive (and still are) the distributors for Elk here in Aus. branded Ness M1". I believe they also make some components and parts for...

Hello DELInstallations,   Thanks for your reply.   Yes, I do off load as much/or where possible to other 3rd party controllers such as lighting controllers etc. However on this job I am using the Access Control with the M1 with approx. 11 doors together with full blown security, and home...

Hello all,   I am new to Cocoon but have been using and programming the Elk M1 (Ness M1) here in Australia since 2005 (geez, time flies !!).   Just wondering if there would be any way to increase the rules capability (memory) to the M1 system? I have on a few occasions run out of memory due to...