Recent content by BassTeQ

I have this sorted now, in the wireless setup, I had to link an activity to some specific buttons.

It's been enrolled into the system successfully.   Radio Interface: http://nesscorporation.com/ness-security/ness-detectors/ness-wireless-detectors/wireless-interfaces/m1-radio-interface.html Button...

Hi all,   I've added a wireless panic button, but can't seem to get the config right. Does this look correct? Have I misses anything?   The product doco says "It will transmit to the Panic channel of any receiver". Do I need to also setup a rule to detect the press and trigger the alarm?  ...

Thanks all for the replies, I've used the desktop Elk software to view the panel log. It also included the "extended data" which shows the sensor that had an issue :)   My sensors are Australian versions, so not 6030 you referred to. They only contain a single battery.   Cheers

Hi all, I have quite a few RF wireless sensors/switches. The Elk event log shows "Low battery on RF sensor" but doesn't tell me which one. Any way to work out which one it may be?   Thanks

Im just looking for a way to add a little more security so the door cant be forced open as easily. As with most options, nothing is foolproof, people will find a way around it if they so desire.   Maglock sell quite a few type of magnetic locks, which would you recommend?   Cheers

Thanks for the reply, I'll chek with the seller if its rated for continous duty.   Its for a "roller door", basically acting as a dead bolt in the roller track. Pretty much like this video on youtube : https://www.youtube.com/watch?v=D9hSp2FClIA   Cheers

Hi all,   Looking at using a ELK-924 sensitive relay to drive a solenoid which will be used as a garage door deadbolt - http://www.ebay.com.au/itm/110884060252?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649   Can anyone see any problems with this? The solenoid will retract when powered, so...

Ive just done pretty much what you've asked, Im running HS and looking at a vera in the near future. Vera can trigger a HTTP command open an event, I've written a asp page that runs under HS, it reads the paramaters passed to it and will update/read the status of a device in HS Eg to read a...

Thats the one, Thanks!

Hello, Im trying to send the audio from the Elk to a single Echo Speaker, and also to a Amplifier for audio distribution. I want to keep the echo speaker ONLY for Elk announcements but also want the announcements to distrubited via the amp to the other speakers. What would be the best way of...

Thanks Lou, that makes perfect sense, I didnt put 2 and 2 together to realise thast because it was a toggle it wont report the state correctly. I have a seperate zone for the door, so I'll use the examples you provided to build some new rules. Thanks again!

Hi all, I have the garage door hooked up to one of the outputs on the panel via a relay. In the output setup I have set a voice description for that output, Garage Door is [say closed/open] But I cant work out how to build a rule to make this work. If I build a rule to run when Garage Door...

Thnaks Work2Play for the reply!

Hi all, Hoping someone may be able to assist with a few questions 1. Is there anyway with the email alerts from my XEP module to include the violated zones in the email body, rather then a static message? 2. When an alarm is triggered I've configured it to call my cell phone, is it able to...