Recent content by bhoth

Thank you, I did this and now it is working. I was hoping it was not that difficult.

I put 12 volt power to the sensor and now the magnetic sensor does not work. I tried it both on the NO as well as the nc terminal. Frankly the wiring diagram is near useless to me. It does not even show 4 wire wiring just 2. It's on a standard basement window. It is mounted with tape. The...

Hi All, I have been using 2 of these sensors just with the magnetic side of this sensor for the last 4 years but finally got around to hooking up the power to enable the glassbreak side but it's a no go. Does anyone else have any knowledge of this sensor and using with an Elk system?   I have...

I have probably 8 foot or so 22 gauge and it seems to be working just fine.

Hi Mike, thank you for your response. I would like your recommendation as I don't know if "Burglar Perimeter instant" is appropriate being it's a detached garage.   Thank you

Hi All, This is my first sensor while adding wireless to my system. I am using the 6022 for a detached garage, so loop 2 will be for the man door and loop 1 will be for a garage door magnetic sensor. My first question is what is the recommended definition for these 2 areas. I don't know if...

The only other action that I did the latest time and did not do before was turn the M1 off, uplug the power adapter and also unplugged the battery. I let it sit 15 minutes, then plugged it all back in and turned it on.

I moved the M1XIN to address 10 and now it's resolved. Thanks Mike for your help!

No sorry, I missed that I will fix that now.

Thanks, I might give that a try when the wireless stuff shows up. I have ordered it online.

Hi Mike I hope you don't mind, I am going to post this same problem on the Elk forum and see if Brad from support can help.

Would it help if I took a picture of the ELK-M1DBHR. I have 3 keyboards hooked up to it plus the M1XIN.

I just realized the time on my M1 Gold is correct but the day is 1 day ahead! It says 9/13/16.   I have double checked the location and it's correct. The NTP settings say it succesfully picks up the time.   Running the latest 5.3.10 firmware.

Here is a screenshot of the enroll screen. As you can see it does not show 2 M1XIN expansions, it shows 1 at address 3.  

You can't delete a zone individually, all you can do is Disable (clear) each zone. So I did that again for each zone then sent it to the system for each zone cleared. Then when I did this for all 16, I removed the hardwired EXP 2 again. then sent that, then checked for conflicts and all 16 zones...