Recent content by bkiedro

  Yeah, I had issues with a VRC0P and replaced it.  It works really well now. The issue was with the Vizia RF installer tool as well, so I can't blame it on the VRC0P.  Again, the range extension function has worked flawlessly.

Great question! I have no idea why it wouldn't work.  It seemed to Associate, but the command I would send it from the RF installer tool and/or the Omni itself would not turn it on/off.  The folks at Inovelli even sent me another one to try.  No dice... Weird...

Thanks!  I believe that helps me.  Much appreciated!!

Could you provide me with an example of what you are referencing?  Not sure I follow how that would work.

Hi there, I'm looking to connect a wireless dry contact relay to my OmniPro II.  Is that possible? I'm looking to monitor a contact and I can't run wire to it.  Any suggestions?

I have used these in my network and the range extender portion works very well.  I have now included my shop which is about 30 yards from my house.  That said, they switch itself does not work.  I can't control the outlet(I didn't buy it for this functionality), but again, the range extension is...

Hey Guys, Thank you so much for the quick response.  I figured it out...  As Pete and Ano mentioned, the circuit that i was connecting to had power on it.  I have a new contact board coming this week, so I should be in good shape then.  I appreciated the suggestions and nudging!

Hello everyone!  I'm struggling with this same issue but I can't seem to get over the hump.  I have connected my holding tank alarm to an input on my expander board.  I had a resister in series and everything worked fine, but it was "opposite".  It was always in the not ready state.  It flipped...