Solved- i switched from the 16v-10va transformer to a 24v- 20va transformer. Since the ELK930 looks for a 900ma draw, increasing the voltage decreased the current draw. Also, a side benefit is the doorbell ring is louder.
Will continue to monitor but hoping is solved.
Thanks ano - that sounds very logical. The ELK will not be seeing the current draw of the ELK but only the current draw when the chime is triggered. But, think I will need an additional pair or wires up to the chime to connect it after the ring pro which is in the chime box . I will have to...
I found an additional clue - the first time the ELK reported the inputs shorted was at 11PM a few nights ago. I have a program that at 11PM turns off some lights on the front porch. This could have increased the power draw of the Ring if it has some sort of variable IR output based on existing...
RAL - thanks for the suggestion. As this is a random occurrence that seems to occur mainly at night (when the RING has the IR LEDs on for video), I will try the following - switch the Ring wiring onto the other doorbell inputs on the 930 to rule out issues with the 930 inputs (these are...
I installed the Ring Pro 2 weeks ago with power booster. It still rings my standard electromechanical chime. The problem is with the ELK-930. It worked perfectly for 2 weeks. Two nights ago for no reason, the ELK started to report the doorbell shorted (closed). It stayed that way for about...
Just a followup - there have been no incidents of random beeps since I implemented all the suggestions from ELK engineering. Not sure which of the 3 changes did the trick, but I consider it solved. A thank you to engineering at ELK.
Engineering has me trying a few thingsto see if eliminates the issue. Downgraded the firmware a version, disabled the temperature sensor so the display doesn't refresh and erase possible messages, disable a few CO related rules.
Will run like this for a period of time to see if it worked. Went...
No log entry at all. In my previous post you can see the log from the yesterday morning event showing no event related entries.
Seems like changing a user code would give 3 beeps as an acknowledgment and not continue beeping for minutes.
Might be best to turn this over to engineering to see...
I got lucky and the beeping occurred just now. The keypad lcd had no useful information. The beep sequence was 3 beeps, 3 beeps, 3 beeps for about 3 minutes then it stopped. I took a video of the keypad while it was beeping. Hoping the link below works so you can view it and possible give...
Here is my ELK log for recent month - on 3/3/2016 at 7:12AM was the arm to stop the beeping. You notice we have not used the alarm at all and no faults show up.
1
Thu 3/3/2016
21:20
1
1363 = REMOTE PROGRAMMING
2
Thu 3/3/2016
7:15...
delinstallations - I will check on reporting is going to the central stations
mike - it is beeping continuously, but in the rush to turn off the beep both myself and wife have put in the code before reading the panel display. So I'm not sure what is on the LCD. But, the log has no entry at all...
mikefamig - yes, as soon as you type in the code it stops beeping and system starts to arm.
delinstallations - I will have to do my best to see what the display says next time this occurs. That will be the only definitive way to know that the system is complaining about. Will also not hit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.