Recent content by bonster

Ben, I have similar system and am in Melbourne and may be able to offer required help. I have a bit of "my documentation" that I created when system was setup that may help answer some of the queries.Give me a call on 0407448859 and we can discuss.

With Leviton stating OminPro II is end of life then why would you start a new implementation with that product ?

and the answer ended up being no, you need the SIP server to handle the communications from the Helios to the Omni so the announcement can be activated.

Hi,   I have a Helios 2n Intercom connected to an OminoPro II and am wanting to know if you can activate an "Announcement" such as "Visitor at Front Door" via the Omni without a SIP server. ?   If so, how would you configure both devices for that outcome ?   Thanks,   Peter 

Thanks for the responses. I don't think I can use an Omnistat2 as I would not be able to control the zones from my review of the manual. I am out of my depth here so will get someone in to look at it. Thanks, Peter

Hi,   I have wired in my Brivis Central Heating to OmniPro relay but cannot get it to fire into action. On the Brivis controller there is a external interface marked C Y G W & R. I was advised through Brivis the W & R control the off and on and have wired to those connectors.   At the OmniPro...

thanks JonW and Desert, appreciate you taking the time to respond with the answer.

Hi,   I have been changing the names of the lighting units within UpStart (UPB) application but cannot work out how these get uploaded into Omnipro II and subsequently down into my iPhone with updated names.   If I go into PC Access application (Ominpro) I can see the lighting unit names...

Hi,   I have an Omino Pro II and when I leave the house and hit the "away" button on the controller to activate security it places it in "day" mode. If when I go out I activate via my iPhone on "away" it holds the setting ok. Any ideas what is wrongly configured to stop this behaviour ?   Peter

The beeps are back so the reesetting of the connection did not seem to do the trick. As I have an answering machine based on the above response "I need to reset the rings on the each device and the Omni so they don't conflict", now might I go about doing that ?    Peter

I disconnected the Omni and it did not happen. I reconnected the Omni again and  it also did not happen. So it seems at this stage that a re-set of the connection appears to have fixed the problem......at least I hope so. Thanks for taking the time to respond.

Hi,   I have had an OminProII installed and when ever I use the phone for normal calls about every three minutes or so the phone will beep three times. I read in the manual how OmniPro security connects to the line on any call to check for # key but then disconnects. This sounds like the...