Recent content by Bubba579

I'm out of town for training this week, so far no resets. I'm thinking the issue may be in the panel thermally. It didn't click originally BUT that room actually has a 5 degree swing because we have heatpump water heater and all the VMS server/network/AV equipment is in the room so at night it...

I will get counts, draws. I'm leaning away from thermal because there is no temperature change in the house. Stays at 71 year round. Conditioned encapsulated crawl. Attic never gets more than about 75 degrees even on the hottest humid windless days. I ran all the wire myself and was extra...

Thats just the last week, I was pulling that via eKey while I was eating lunch. I'll pull a more recent log via RP and see if there's a statistical mean. No zones are violated, sensors are stable. I tested with a fast response and no issues. Voltages are stable as best I can tell.

5/20 @8:51PM 5/22 @9:03PM 5/24 @11:47AM @10:31PM 5/25 @11:53PM 5/29 @4:33AM Are the last few times in the log file a reset has occurred. The wires are all run through conduit up vertically on interior walls. The house is closed cell spray foam on exterior walls so there should be...

Thanks for the assistance, this problem has persisted and I'm not quite sure what to do next.

All the sensors are hardwired homeruns back to a single enclosure. Bus between inputs goes to a M1DBH via CAT5e.(I took it out and used terminal blocks issue is still present) It's all over the place time wise, usually at night around 11-2 but sometimes during the day. If it didn't ignore...

Yes It's on a supported firmware, I could try to roll it back. Haven't yet. I have checked bus, swapped the M1DBH out. Re worked and tested the RJ45 connectors. Checked bus voltage. Checked Power supply voltage, swapped power supply. Checked grounds. Replaced battery.

M1XEP yes

I have an ELK M1 60zones, Fire, Burg, Elk Wireless, 1output expander. I have an access control system providing 2 relay output to trigger a relay and my garage door. The relay triggers a keyswitch zone to disarm the alarm upon activation. Occasionally, the M1 will just reset, when it does I...