Hi Cornutt
In your programming you mention then Run Garage Door Close. What do you have programmed into the omni to close the garage Doors. That is one area that I need to control better. I installed wireless tilt switches to let me know when the doors are open, but that's it. I would like to...
Hi rismoney
stumbled onto your thread and thought I would send a reply. My system consists of an HAI Omni Pro II with Russound CAV and CAA units. I have the Uno keypads in the rooms, however I use Casatunes to run the system. Casatunes is excellent. The guys there are great and are there at...
When I was using UPStart, I was able to find all the devices and set them up. Then I figured out that I should have let the HAI set up the devices so I could gain status control. So I set up all the devices properly by room and then started to program them. That is when I found out that the...
Hello All,
I am having troubles with trying to get my HAI Omni Pro II to find and set up some of my switches. It looks like it cant see the sub panel that is in my bedroom closet because that is where most of the circuits that it is having trouble seeing.
When I originally used UPBStart...
I think from my perspective that ML is a bit easier to understand and program than CQC. I have tried both, to some extent and I am about to pull the trigger on ML with a few plug in.
I think they still have the deal where you get the whole suite for a pretty good savings.
Sorry for the UPS, my bad.. Anyway I have been able to get them to respond using the Receive components under edit device, however I still can't get it to work right. Also what do the groups 1,2,3,4 mean?
Boy this indicator thingy is strange
OK, I have UPB working with the software and I am configuring links. However, something so simple is driving me crazy :P
This is all I want to do. I have a 6 room HAI keypad. Hit the on button and the on button lights up and the lights come on..great Now I hit the off button....I want the...
Hello all,
I have been searching for a while now and cannot find it. I am looking for a sample UPB file that shows how the switches, links, etc all work. I downloaded it before, but I cannot find it now.
Does anyone have this sample file showing how to setup UPB switches
Thanks
Ok, A bit confused. I was just going to use the HAI Powerline module to program it and then plug it back into the HAi when I am done. That won't work??
OK, I found my Serial pc adapter and I hooked it up to the computer and plugged in the powerline interface module and tried to run the software but no luck. It cannot see the module. Any suggestions on how to get this to work?? I tried it on two computers and no luck and I know the serial...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.