Recent content by drfergu

It appears that the noise is happening when the X10 transmitter is connected to the Omni Pro.  The unit is the TW523 X10 Powerhouse line interface unit.  This is strange because the noises are happening when the X10 commands are issued but also when inputs come into the Omni Pro and no commands...

Yes I am.

I have an Omni Pro II with the sound card connected to whole house speakers.  This is used to have the system make announcements when outside motion detectors are activated.  The system makes noises through the sound card when inputs come into the Omni Pro.  These can be presses on the remotes...

I did make a copy of the system with the pro version of PC Access.  When I reload any of my old versions the controller shows the expansion card, and the wireless receiver that is set up as 4 expansion units, due to the number of remotes I have.  While the controller thinks that it is able to...

    I believe I have found out the problem.  When I put in the new PROM it appears that while the automation instructions remained intact, all the system parameters were wiped out.  Therefore the main board did not know about the expansion board or the wireless key receiver.  Since I just moved...

I have an OmniPro II from 2002 and an expansion board and a wireless receiver feeding into the main board.  I just tried upgrading the ROM from 2.3C to 4.0B and had problems with the wireless transmitters not working so I went back to the original ROM and the problem is still there.  When I use...