Recent content by gmtech

Hi all!   I'm writing an interface through MIT App Inventor 2, but i can't read values of variables. I can easily set vars calling "webviewer" (set hidden previously into interface), but through "web" i am not able to read anything. Everytime (even if i remove password) i cannot read nor input...

It recognizes also comments between # (e.g. #this is a comment#). Remember to delete them before importing into PLC. Until CAI introduces comments into code! :-P   GM

Hi all! FYI i did a config file that you can import under "Language", into Notepad++. In this way the code and the operators are recognized and easier to read and to write.   Best regards,   GM

Hello CAI_Support,   For different purposes (e.g. to fix MAC lost address happened with some upgrades, Internet provider MAC check...) please add this option under Network Setup.   Thanks in advance,     GM

I followed exactly your steps, and it has been not my fault. So please we must find a solution to change the MAC address. If it can be deleted, it can be re-programmed. So FIND a way to solve this trouble.

I was connected through an access point to the network (Linksys E4200), that is connected to a Cisco 877, where the WC8 is connected. Please read my first post, i cannot send the board to you, it will be very expensive (from Italy) and i cannot wait one month for the board. I am really...

I reply to myself. The hardcoded IP is the default one (i.e. 192.168.1.15), and i successfully recovered the firmware! One little problem, now the MAC Address is FF:FF... All "F". And the NTP server reject connections with this Mac Address...     Any way to restore the original one or simply...

Thanks... I tried some times but it seems it doesn't reply... I'll try many more times. In the first three seconds which is the hardcoded IP? Am i wrong to ask this? If i reset the board even if the firmware is corrupted will the IP address become the default one?

Hi all,   i have WC8 board with 3.02.17g firmware that i tried to upgrade following the guide and downloading files from site. I launched bootloader through browser (and board stopped running PLC code), and started blinking LEDs as requested. At half of uploading new firmware stopped blinking,PC...

I'm sorry i don't want to discuss your internal "factory behaviour", and your gains. I believe it's not because of money. Here people like me can write code in almost all existing languages, build up interfaces and so on. "Hardware limitations" are difficult to believe. Maybe you didn't think...

Sadly there's no cheap international shipping service, and if you use the national post service of course time together with results will be unknown. Spend 40$ two times to ship a 35$ item has no sense. I read many posts where people asks for firmware upgrade software. I understand that maybe...

P.S. I'm sorry, a little bit OT, but due to all push services available i suggest to admit longer destination mail, because of API addresses (and optional switches).   Waiting for your help,   Andrew

Thanks for your prompt answer and your kindness. I did some miracles to buy two of these, here in Italy there's no sellers at all, and i spent more for shipping than devices... :-( So send them to you it's quite impossibile. I could build any interface you need, and please consider how i did to...

Hi CAI,   first of all thanks for your beautiful device. I used it a lot, doing a home alarm, but sadly i need to notify different things to different email addresses, feature supported in (at least) tha last firmware. I have 3.2.11 firmware with (i think) 2.2.2 hardware revision. Reading your...