Recent content by ioguy

  1. I

    DSC Motion Sensor Trips Before Recessed Door Sensor

    Sorry, Should have gave more details. 1832 v4.5 Motion is set as zone type 05.
  2. I

    DSC Motion Sensor Trips Before Recessed Door Sensor

    I have a relatively new DSC install that I noticed an issue with.  When coming home yesterday (Armed - Away), the motion sensor tripped (set off the alarm & siren) prior to the door opening signal (so there was no Opening Delay).   The sensor points right at the door (about 10' away) and must...
    • ioguy
    • Thread
    • Replies: 3
    • Forum: Other
  3. I

    Honeywell IAQ Thermostats with Elk M1 Gold

    Yes, Hard-coded commands could be sent over RS232 for climate setpoints. Virtually all settings (a couple small exceptions) can be accessed over an Enviracom adapter. I'm assuming your system uses the Enviracom bus (I think all IAQ do). You could tell this by your thermostat wiring - the...
  4. I

    Honeywell IAQ Thermostats with Elk M1 Gold

    I haven't seen much success with anyone tapping into the RedLink protocol. You'd likely have more luck with IAQ over Enviracom with a W8735A RS232 adapter. There's a number of code snippets (various programming languages) over the web that may help Enviracom integration into Elk. I have my...
See more
Back
Top