Recent content by Jason B

Thanks, I'm just not sure what I should be cutting and where. I figured it out on the WS467, but this one is hard to tell.

BLH, here's an interesting test I just did. Remember that WS467 applicance module you helped me mod? I put that into the stock outlet as a test. Turns on/off, no led pulsing! How funny is that? 

Correct, if I ever moved out, I'd need to put gfi back in to meet code, But yea, play it safe with the extension cord, then I could keep all that junk out of site from that outlet and use an appliance module I think... Still want to see if there is something to cut inside the sr227 to see if it...

Ok, here is another post where some say yes it should work and no, Near bottom of post again. http://forums.x10.com/index.php?topic=17143.0;wap2 - Let me show a picture. I'm not sure where I'm looking at, maybe you can tell me if it's surface and if I should try. Not sure what to clip, but I'm...

This is in an area that I can't put a night light in. In this case, there is no issue turning the leds on and off, it works every time. Just the led flicker when off. My issue last week was getting thigns to turn on/off, now this. lol. So, the instructions online, some say cutting that diode...

I read of a fix by cutting a diode that will stop flicker of CFL, would it fix the flicker for LED? See reply near bottom: http://www.x10community.com/marko/2006/06/disabling_the_local_control_fe.html  

http://cocoontech.com/forums/topic/25399-replacing-existing-outlet-with-an-x10-sr227-questions/#entry244044 I have a strip of leds controlled by an X10 Sr227 wall outlet. The leds flicker when off every few seconds. Are you telling me I have to do the same thing with the night light to stop the...

Thanks, well, I just hooked it up as a test. The x10 outlet I have, has the top outlet that is controlled liked mentioned. I have a led strip that is plugged into it but when I switch it OFF, the led flickers every few seconds. Crap. I read about this problem before with leds. 

It's in a bathroom, I have led lights under a vanity and would rather use this, than an appliance module. I don't use a hairdryer, etc. just looking to keep thinks sleek. I could install a seconds outlet inside the vanity cabinet, but really don't want to do that,.

Thanks, the other thing I can do is put an applicance module in the outlet, but that's going to look ugly. 

Is it a big deal to replace a gfi with an sr227? I don't really care about the protection of the gfi in its location.

Ok, the way to fix a blind that when it's halfway UP when batteries are dead (pre 2.0 powerrise) is to pull down on it while hitting the down button multiple times, until you get the shade fully to the BOTTOM. Then it will reset itself and work like normal!

Done! Now, I can move this behind a dresser and then can make it invisible  

Darn, didn't work. Looks like I'm going to need to add the led night light, to get more current in there. What's the best way to do that with this module. Get a cube, with two plugs, and then plug in my device and the nightlight? Just trying to see best way to fit it in. I did same thing with...

Ok, finally found it and cut jumper. See pic. Will re-assemble and test again. There is only one jumper it seems, so this must be it.