Recent content by lubeto1977

Did anybody try to pair Lutron Connected Remote? http://www.lutron.com/en-US/Products/Pages/Components/ConnectedBulbRemoteControl/Overview.aspx If it can be enrolled and used with Omni, it would be a great remote button to controll lights, scenes, macros and etc.   So far successfully connected...

ano,   By any chance have you ever tried the NYCE sensors and devices with HAI? They support ZHA 1. IT would be nice if we can use their small and inexpensive occupancy sensors.

Hi, Wanted to know if anyone interfaced a Hayward Pool equipment to HAI Omni via RS485? I am looking for Hayward Pro-Logic RS485 protocol so I can read and write from the Aquarite controller.   Thanks,

I did purchase a Cree Connected bulb from Home depot. The HAI ZIM could not discover it. Later I used a TI IEEE 802.15.4 rf sniffer and upon reset the Cree communication packets looked like ZLL. The GE bulb work good and also act as repeaters. Like "ano" mentioned in his post above, Zigbee...

The Cree bulb would not work with HAI ZIM. Cree uses ZLL protocol. The GE Link are working great as well as CentraLite control modules. Both tested and working.

Thanks for your reply ano. Very helpful information. Cheers!

Hello, I was wondering if a HAI Omni system with ZIM can control some of the new Zigbee light bulbs? HAI states that supports locks, thermostats and load control modules, however under PC Access one can set up a light room to Zigbee. The Zigbee has two sub standard ZHA (Zigbee Home Automation...

Hello, I would like to setup the HAI wireless motion detector as occupancy sensor. Can somebody give me a advice hor to do it. With a normal motion I can set a flag that will turn on for some time when the zone is not ready. With the wireless one that can not be implemented becouse of the...