Recent content by mdruno

eBay UPB Computer Interface Module PIM UMC-DB9-W Without Serial Cable SAUMCDB9W US $21.99

Got a second PIM and all is great. Thank you for your help.

I was trying to do it with only one PIM. Sorry for any confusion. I purchased one last night and I should have it Monday.

I think that I may need to break down and purchase a RS232 PIM.

Ordered, be here Thursday.

Your help is greatly appreciated. Thank you for your help and time. I will play with it more tomorrow.

I found an old serial cable that with an RJ 11 to a DB 9 that I have used in the past to program my HAI before ethernet. I just tried it and I can communicate with my OP2. But I still can not communicate with the PIM.

I tried just TX, RX and Ground and still nothing.

I see a discrepancy with pins 7 and 8bon the DB9. The wiring diagram you sent earlier has pins 7 and 8 jumpers together and you last photo shows no connection to pins 7 and 8.

Thank you. I tried to connect just as you have detailed. Still no luck. The PIM that I am trying to use is the HAI 36A00-1 UPB Powerline Interface. Once I plug the PIM into an outlet the status light flashes red 3 times, flashes green one time then goes to solid orange. Same result when the...

Thanks for your help. I tried to make a cable based on what I read in the 2015 thread. From the RJ11 to the DB9 as follows: RJ11 DB9 Pin 1 - Pin 5 Pin 2 - Pin 4 Pin 3 - Pin 2 Pin 4 - Pin 3 And I can not establish a connection in UPStart.

Thank you for your input. Do you have a wiring diagram for the RJ connector to the DB9?

I have the Omni PIM with the HAI cable. Can I simply get another cable and put a serial DB9 on one end to connect to the PC?

Thank you for the quick response. Can you talk me through doing it with one? I hate to invest more money if it is not going to work.

I have an Omnipro II and I have just came across several UPB switches and a PIM and cable from a friend. I do not currently have a UPB network. My question: do I need another PIM to connect to a PC for programming or can I use the same PIM that is connected to my Omnipro II by disconnecting it...