Recent content by mikeindustries

Hi there. Not sure how long I've had this problem (possibly forever?) but I can't seem to get my Leviton Vizia RF+ devices (dimmers, switches, etc) to report changes in their status back to my HAI Omnipro II. It seems like the VRC0P is working fine because I can operate the switches remotely via...

Thanks mikeybob. I will switch over the mode setting and give it a shot!

Hi there. I've been using an Omnistat 2 for about 5 years now to control a Rheem Electric Heat Pump with a gas furnace backup. I have noticed that the gas furnace never turns on unless I manually turn the mode to "EM Heat".   I thought, for some reason, when this system was installed that the...

Hey all. I have a Somfy ILT hardwired motorized blind system tied into my OmniPro II. It's worked great for several years, but the only interface for raising and lowering the blinds is issuing commands via the OmniPro (they are set up as individual units and as a group in PC Access). Generally...

Has your Russound audio status stopped working with the 3.10a update? I can still successfully send commands to my Russound units but the statuses never update in either PC Access or Haiku. Basically, two zones are stuck in the On position and the rest are stuck in the Off position (again, I...

I'm not sure if this started happening right after the 3.10a firmware update or not, but none of my audio zone information updates anymore on my HAI OmniPro II. I can still successfully send commands like On, Off, Volume, etc to the Russound units, and they respond, but their status never...