Recent content by mjjafari

Thanks to you Pete and others who helped me here, I sorted this issue out , the powerline interface was sitting on a different Circuit Breaker in the switchboard. Does all X10 gear need to sit on the same mains circuit ? When I try to control devices distributed over different circuit breakers...

I can see them for sale on X10.com but Im from down under and need them to be 240v not 110v you guys have in US. Searching on Amazon and eBay didnt get me anywhere. Any ideas ?

Thanks for everyone's help, I changed the cable and now the X10 interface doers a "double blink" when I send a command from M1, but none of the X10 devices respond. I'V programmed correct house and unit numbers in M1 , but no response. what are the common troubleshooting guides when X10 does not...

Thanks Pete, I actually need this info for ELK M1 X10 port, It seems ELK has not published the pinout of their X10 port ( J5)

Thats a very good point, but the issue is I cannot find any info on the pinout of the X10 connector on M1 , do you have that info ?

Before we upgrade to M1 , the X10 was connected via the same interface I'm using to a HAI OMNI Pro2 and it was working fine  The M1 is connected to the X10 via a power interface , I've tried two different one ( X-10 Powerhouse XM10E-120) (Winplus HA124) , these interfaces were working with HAI...

I'm in Australia and trying desperately to get an ELK M1 to control an X-10 lighting with no luck , is there anyone who can help me here ?