Indeed the problem that remained once I terminated J3 on the main board was that my M1XIN was at bus address 4 and I was expecting it to show up as Zones 17-32. I changed the address of the XIN to 2, as gatchel suggested, and all my zones appeared "Normal" except one window. Upon closer...
All of these zones are doors and windows supported with normally closed magnetic contact sensor switches. I have several similar zones configured on the main board which appear to be functioning normally.
The M1XIN zones (17-32) are all the same: "Type" is "Normally Closed", their Definition...
Yes the jumper on the M1XIN was installed in the "No" position. Sorry, that wasn't' clear from my description. Thank you.
However, JP3 on the main board was not terminated... It is now and the changing values for hardware, firmware and boot versions on the M1XIN are no longer changing.
So...
Hello --
This is my first post to CocoonTech and I'm new to the Elk M1, so please be gentle!
The forums moderator upgraded my access to allow me to attach some images that help show my problem. Thank you.
I've recently installed an Elk M1 Gold (firmware 5.2.4) with two keypads on bus...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.