I have not yet messed with firmware updates. Here are the versions I see. Should I be upgrading?
M1G
hardware: 0.13
boot: 3.3.2
Firmware: 5.1.14
M1XEP
Hardware: 1.0
Boot: 1.1.4
Firmare: 1.2.14
M1KP2/KP3
Hardware: 1.4
Boot: 3.0.14
Firmware: 2.1.48
Yes, I'm connecting properly and the Sunrise/Sunset Timezone settings are definitely being saved to the M1G and I can read them back no problem.
The ghosted out TimeZone setting on the M1XEP sometimes says +0 GMT and sometimes reflects the same value that has been set on the M1G (-8 Pacific)...
I am, yes. I've tried all manner of incantation... change TZ in M1G, reboot M1XEP, update time server setting on M1XEP, change time of time server sync to force time server update, test time server...
I have an Elk M1G with the M1XEP. I've programmed the M1XEP to use a time server to keep the clock up to date. I programmed the Time Zone offset in the Sunrise/Sunset area as instructed on the M1XEP screen. However, my time zone setting doesn't seem to be working properly. The displayed time...
I have an Elk M1G system. I'm well acquainted with the manual and the ElkRP software. I use "Night Instant" mode when I go to bed. The "instant" feature is working as specified in the manual such that there's no "entrance delay" before the alarm goes off when a door is breached.
However...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.