Recent content by slowmo

No Central Station, the Alarms just went off in our house. The log showed no "Area Armed" at least for the same day.  Looking back over the log there is one line 1299 = Duress by User 1 (me) which initially assumed it was associated when I used the M1ToGo to shut off the alarm.  Since no one was...

Something caused our M1 to trigger an alarm event this evening.  The M1 wasn't armed, as far as I know,  The cause of the alarm is unknown at this point, although I like to nail down the cause.  We are not hooked to a Central Station so I cannot retrieve a log from a third party.  I looked...

Wuench, thanks... changed screen font size to small (100%) from medium (125%).  Another satisfied customer...      

  Hi all, Just getting around to asking this question.  Normal IP Addresses contain 4 sets of numbers. However on my XEP TCP/IP Settings Tab it only shows the first three sets of numbers.  It’s the same in all of the boxes where an IP Address can be entered, i.e., IP Address, Subnet Mask...

I guess it was wishful thinking on my part that the “Synchronization Fail java.lang.arrayindexoutofboundsexception length=8 was something I could fix on my end. I knew the risk of getting this app going in and certainly got my money’s worth while the ElkDroid worked. I grew custom...

Any luck contacting Kent regarding Elkdroid? I tried a week ago with no luck. Last week my ElkDroid app stopped synching. Elkdroid Connects at launch, then Authenticates, gets Zone Names, but at the point of getting Key Pad Area is crashes with “Synchronization Fail...

Dan, Can you provide me with more details? Work2Play and Lou, I will try your suggestions, I need to digest them first and with a little luck and random key hitting I should get it to work. Thanks all, Scott

Can an Elk Rule Cancel another ELK Rule? Is there a way to cancel a rule through a command such an OUTPUT For example: WHENEVER MOTION DOWNSTAIRS HALL AND IT'S DARK THEN TURN ON OFFICE LIGHT FOR 3 MINUTES This rule works because it turns on my office light just...

Makes sense, I will give it a try

How can I differentiate between an UPStart Channel 1 and Channel 2 of a SA US22-40T switch in ElkRP? ElkRP ties to UPStart UID yet SA US22-40T only uses one UID. Is it possible to set SA22-40T on two UID?

Cocoontech Forum is awesome, Work2Play ditto. I’ve learned more about Elk rule writing through our exchange than 6 months worth of reading on my own. OK you can take that one of two ways; either I’m slow or you have been very helpful. I will ponder this a little more when I have time this...

Work2 Play Thanks again for the feedback. At various times of the day I’m checking Thermostat settings. I’ll report back when I’m comfortable the rules are working as expected. Just so I understand your thinking in your second to last line. Using your rules, Rule 1 Out53 starts for an...

I added a few rows of code. -- AND Outside Temp… because there is a point where the outside temp is not low enough to turn on heat. -- AND RCS TR40… this line allows someone to set the temperature higher than the temp set by motion detection. This way motion detection does not override a...

Thanks!! I will give it a try.

I’d like to get feedback on the Elk Rules below. The intent is to increase the thermostat setting when there is movement in the house and then to decrease the thermostat setting after an hour of no movement. The motion sensor is in the family room/kitchen area thus it is high traffic area...