I have a quick question. I am wondering how many simultaneous connections the M1 can support.
I am referring to 3rd Party devices not the ElkRP software.
I have recently replaced a M1 panel with another M1 panel. After swapping the two panels over the KP-2 keypad displays "Keypad Bootloader". The keypad can be enrolled, F3 on boot works (brings up menu) but the keypad will not function normally.
I was wondering if there are any solutions to this.
Hi Guys,
Thanks for that. I have got it working now after a phone call to Ness (ELK Australian Distributor) and i overlooked the resistor type and installed the wrong type :headslap
All working now. Thanks so much.
Also thanks BraveSirRobin for the diagram.
Hi Jpmargis,
Thanks for showing interest in my little issue.
Here is the manaul from the Maglock (its a little vague).
http://www.fshlocking.com.au/images/stories/documents/04_Products/04.02_Electro_Magnetic_Locks/4.2.3_FEM3500_Series/FEM3500_Installation_Manual_01-03_LS7.3.1011.pdf
I am currently doing a job (my showroom) involving a M1-KAM and a maglock.
A few details on the maglock
Has an inbuilt PSU
Has the following connections C, N/C and N/O
I have connected the Maglock to the power and have connected the + terminal of the Maglock directly to the N/O of the KAM and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.