Recent content by tehbrosta

Can anyone at least confirm they have set JP5 when connecting an Omnistat2 to an ELK system?   I could wire in a fan center to my boiler and then have the proper wires at the thermostat.  

I have a boiler without a common wire. For about 6 months before I decided I was ready to control the thermostat I've been powering it with a separate transformer. I followed the ELK thermostat & lighting module document, plugged in my thermostat and It immediately let the smoke out. Needless to...

I got it, I had to reverse my yellow and black wires on my RJ11.      RJ11 DB9 PIN-OUTS 4 (BLACK)  ----  2 (TX) 3 (RED)      ----  (Not used) 2 (GREEN) ----  3 (RX) 1 (YELLOW)  ----  5 (SGND)

I found the VRC0P programming manual outlining what you recommended to try.   I tried all of the following options:     The only baud rate that gives me any response back is 9600.     Maybe my serial cable is too long, I have a 7ft RJ11, an adapter and a 7ft serial cable connecting the two...

Hello All,   I'm having a hard time getting my ELK M1 panel to control my kwikset lock. I have my zwave network setup and I can control the lock from the installer tool. I have the VRC0P setup for RS232. I hooked it directly up to my PC and I'm getting a garbled output. It's suppose to be ASCII...

Hello,   I am a low voltage tech professionally but also a big DIYer.   I have an ELK M1 panel and plan on writing some integrations.   One being with a Bose SoundTouch20, I have the proof of concept working, I just have to expand the functionality.   Looking forward to being part of this...

Happy New Year!   I've been a member for a some time now but never needed to post anything.   I finally started diving into doing some integrations, I can't wait to share. I got a Bose SoundTouch20 for Christmas and I started controlling it from ELK M1.