Recent content by tripleJs15

What do you mean by: Add your HAI UPB Switches in HLC Mode ?   How do I do this, you mentioned doing in PCA, but do I need to configure it in Upstart first, per the last sentence ?   Lastly why/what would it change from a performance standpoint ?

I tried a few different things, currently I'm wiring, from the relay, common (blue wire) to zone 1 -, normally closed wire to zone 1+, the jumper is on normal and the setting is entry/exit within PC Access.   I tried wiring it normally open, with a EOL on the panel bridging zone + to -, within...

  Ok, I didnt do any of that, I'll try and report back.

Guys,   I wired in a Kidde smoke alarm relay into the a remote mounted single gang nail-on box in the attic, connected it to the panel using the normally open and the console shows not ready (Loop code 235), I switched to the normally closed wire and still not ready (Loop code 128).   It's wired...

Oh, I see, I tried in PCA and could not figure out, this make sense.

Ok, I didn't realize I can change the unit numbers within PCA, I'll try now.

Ok, that's fixed - now within the Units Section - my theater room nodes/unit numbers doesn't match the unit numbers under "units" within PC Access.

Guys, need a little help.   I have my HAI HIFI2 connected to the HAI Omni board using the cable, but not sure what's next ?   I entered the HIFI2 IP address into HAI PC-Access (Dealer) and that's about as far as I got.     Any assistance would be appreciated.

  Sounds good to me, I'm not traveling for work this week so I can play around with this a little.   I mistakenly added "Living Room" to RM1 under "Units", and cannot figure out how to remove it.   Since RM1 is Unit 001 - when I reference it all my lights turn on, however in UPSTART unit 001 is...

  Thanks for the explanation, that helped a lot!         1 - Omni LTe 2 - UPB all HAI - 6 Dimmers - switches - 16 right now - 4 in theater room the other scattered about the house. 3 - 2 HAI Keypads  4 - outputs - interior only 5 - 8 doors, and 4 motions - unknown 6 - Pre-Wired for 3 cameras   I...

In the room setup, for example I have 4 switches in my theater, does the below look correct ?   RM1 = nothing ? RM1-2 = First Switch, in my case it's the "Screen Wash" RM1-3= Rope Lights   How is rooms used and how do I implement scenes ?

I'm new to HAI Omni and PC Access (Dealer Version), I configured all my switches with Upstart and trying to determine next steps.   When I setup "Units" there's RM1, then RM1-2, since I don't have a room controller do I skip the 1 unit of each room blank and setup unit 2 etc ?   In the links the...

To the top ?

Need someone to assist or to install a HAI Omni system (New) and alarm components, everything has been prewired and I have the HAI UPB switches and module. Any recommendations or assistance would be appreciated. Email is [email protected]. Thanks!

Pete, To confirm, your RC80 is wired to you Omni and worked fine, have you tried controlling it through any mobile apps ?