Recent content by VE9PTR

I just installed a M1KPB and the instuctions say it has a 'speaker' which I can see on the circuit board. Is this an actual speaker or just for the keypad beeps? Thanks.

Thanks for all of the great info! I have ordered 2 sm relays and will give this a try when they arrive, if not I'll try another of the suggested routes. I'm trying to avoid simply inputing the 5v for fear that it may cause problems with either the m1 or the garage door monitor itself. Murphy -...

I'm am almost done installing my new M1G and now none of my user codes seem to work after I added some users. I've tried 4 and 6 digit, changed the code via RP and on the keypad and nothing seems to work. When I put a valid code in, I get a double beep and then the keypad (kp2) shows what look...

I'd like to partition my detached garage into a seperate 'area'. As the M1G only has 1 audio output, I'm looking for some programming to perhaps control some relays on the speaker outputs. I'm thinking just 1 relay for the house, 1 for the garage. What I'm trying to avoid is having someone...

Can someone please explain how I can 'input' a 5v analog signal into a zone? I have a 5v signal (from an LED on a garage door monitor) that I would like to use, but rather than put a relay in, I think I can use the analog voltage value as my trigger. I see in the rules how they are applied, but...

Thanks for the reply! So, basically what I understand is that the 2413s module does not do a good job at x10? I know ZERO about x10 and don't currently own any to test, but I'd like to add some wireless sensors and key fob's to my system and thought x10 might be the way to go. What I'm now...

Hi Folks, I'm new to this whole x10/Insteon/ELK stuff but have my M1G up and running with a few wired sensors (motion) and some contacts to be installed soon. I also have a Insteon PLM (2413s) and ISY-99 up and running and interfaced into the M1. My question is can the ELK pull in data from X10...

Thanks for all the info and help, but I'm still struggling to make the M1 control the ISY. I've done the import and the light shows on the elk pro app but switching it on/off does nothing. Ip and port seem to be ok but where should the security code come from? I've tried some of the defaults...

Hello All, I'm a first time home automation user and I just received my new M1G last week, along with an ISY controller. I'm an electronics tech by trade and looking to setup a complete home security/automation system as time and the bank account allow. I'm got the M1 all set up on my test...