We had a quite windy day around here, so at 13:30 PM I put the probe out in the wind, and now it seems like it's connected and really getting dry:
So now the calibration limits are -1.4 wet and -0.5 dry.
Very impressive page you've got there :-D
Do you have any links to people that have tried to make them work?
Apparently I get the same reading from the Current Register whether I put the probe in a bucket of water, or put it out in the open air. About -1.34. It seems to be highly temperature dependent too, but I'm not sure.
Thanks Eric. I dropped the sensor in a bucket of water this morning, so hopefully this will give me the 100% limit tomorrow. Then I'll bring out my fan heater and dry it afterwards to get the 0% limit ;-)
I'm writing about the project on http://happyfarming.com.
I'm using the Moisture Meter MM2-R1-A together with the Watermark Soil Moisture Sensor WGS1-P and I'm reading the current register of DS2760 to be -1.43437 via 1-wire and owfs.
Is this reading in volts? How do I convert -1.43437 to a useful soil moisture unit? Maybe kPa or something else. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.