franklyhollywood
Member
Hi. I apologize, but when I searched through the forum, all I saw were comments and directions on how to connect the two for control of the Nuvo GC, I could not find the answer on how to configure the OPII, and Nuvo GC to announce through the GC. Does that make sense, I hope???
I have the Two way communication board, the latest firmware for the OPII and PC anywhere. I also have the latest firmwares and Configurator software for the Nuvo GC.
I know I have to run a mini jack out of the Two way communication board to an input source on the Nuvo GC. then I have to run from the two way board to a mini in on
what port in the Nuvo GC?
Then how do I configure the Nuvo GC software?
When I select source 6 in the configurator software, which is where the OPII is coming in as a source, it is asking me to select a device to associate with source 6, and in the list there is no HAI selection.
Also, under the system tab, what do I select there?
Thank you so much for your help!
I have the Two way communication board, the latest firmware for the OPII and PC anywhere. I also have the latest firmwares and Configurator software for the Nuvo GC.
I know I have to run a mini jack out of the Two way communication board to an input source on the Nuvo GC. then I have to run from the two way board to a mini in on
what port in the Nuvo GC?
Then how do I configure the Nuvo GC software?
When I select source 6 in the configurator software, which is where the OPII is coming in as a source, it is asking me to select a device to associate with source 6, and in the list there is no HAI selection.
Also, under the system tab, what do I select there?
Thank you so much for your help!