IVB
Senior Member
I'm trying to set up an Elk-120 to use as my doorbell. The doorbell is wired to a zone, has worked fine for years as I was using CQC for the doorbell.wav playback.
But now I can't get the Elk to turn on an output (relay) so I can provide a momentary power pulse to the 120.
Here's the rule. The funny bit is that the announcement goes off just fine, but the relay never turns on. I've sat there and watched it. And, the test of the rule goes fine.
Any hints?
WHENEVER Inside Doorbell (Zn 58) BECOMES SECURE
THEN ANNOUNCE Inside Doorbell (Zn 58)
THEN ANNOUNCE Miscellaneous 1 (vm239)
THEN TURN Inside Doorbell (Out 17) ON FOR 4 SECS
But now I can't get the Elk to turn on an output (relay) so I can provide a momentary power pulse to the 120.
Here's the rule. The funny bit is that the announcement goes off just fine, but the relay never turns on. I've sat there and watched it. And, the test of the rule goes fine.
Any hints?
WHENEVER Inside Doorbell (Zn 58) BECOMES SECURE
THEN ANNOUNCE Inside Doorbell (Zn 58)
THEN ANNOUNCE Miscellaneous 1 (vm239)
THEN TURN Inside Doorbell (Out 17) ON FOR 4 SECS