IVB
Senior Member
Just replaced my M1DBHR with an M1DBH (which i'm regretting, but that's a different post).
I used to have the M1DBHR (in the basement) and an M1XIN in a 3rd location homerun back to the M1G, both sets of wires put into the +/A/B/- databus, no M1G termination, and all good.
But the M1DBH manual says to only terminate the M1DBH and the Elk panel.
I hate to ignore manuals but can I terminate at M1DBH (in basement), M1XIN (in attic), and leave my wiring as-is with both sets of wires directly into the M1G data bus?
I used to have the M1DBHR (in the basement) and an M1XIN in a 3rd location homerun back to the M1G, both sets of wires put into the +/A/B/- databus, no M1G termination, and all good.
But the M1DBH manual says to only terminate the M1DBH and the Elk panel.
I hate to ignore manuals but can I terminate at M1DBH (in basement), M1XIN (in attic), and leave my wiring as-is with both sets of wires directly into the M1G data bus?