drozwood90
Senior Member
Did we ever find out if the wires were plenum rated or not (i.e. "legal" to be pulled through a heating duct)?
--Dan
[Review] MicroFlow 2000 automated registers
- Thread starter Chakara
- Start date
Did we ever find out if the wires were plenum rated or not (i.e. "legal" to be pulled through a heating duct)?
--Dan
Did we ever find out if the wires were plenum rated or not (i.e. "legal" to be pulled through a heating duct)?
--Dan
I remember talking to a rep from the folks who make this thing and the answer was "No, the provided wiring is not plenum rated."
drozwood90
Senior Member
Hmm...so, they want you to pull it (from a previous post) through the existing vent, but it's not plenum rated?
--Dan
--Dan
That would be correct.
I don't think so. The wiring provided is relatively short - and at the exit point of the duct. You could also find another way to get the wire there rather than run it through the duct. However, I believe if you run it through the duct you should use plenum.
Again, I'm not an expert....
-Chak
Again, I'm not an expert....
-Chak
drozwood90
Senior Member
I was under the impression they provided 100' of cable. As I am guessing this is not the case any longer...the wire they provide is not intended to be in the duct. It is just the 1' or so attached to the unit. If you pull through the duct, I need to provide my own (which would need to be temp rated and plenum).
???
--Dan
Not if their web site is any indication of current product:
http://www.automatedceilingregisters.com/
