Recent content by alanethomson

  1. A

    HAI OMNI Pro II , UPB and motion

    I have an OMNI Pro II panel and want to add a few UPB switches.  I have a HAI UPB PIM however no cable.  It is my understanding that one needs an RJ12 to RJ12 cable with the Tx and Rx wires reversed.  Is there a supplier for such a cable?  Failing that is there a pin out of a 6 six conductor...
  2. A

    OmniPro II networking setup.

    This is an update.  I found the problem.  The default IP address is 192.168.0.101 and my LAN address is 192.168.1.1.  I read the installer instructions to read that the last two octets did not matter as long as the first two octets were the same.  Well, that is wrong.  I changed the Omni Pro...
  3. A

    OmniPro II networking setup.

    I am having trouble with the network setup of my Omni Pro II.  The Omni Pro has been used as a security system and it functions fine.  I even have a few X10 modules set up to turn on two lights.  I decided I would like to do more ALC and HVAC programming so I got the Dealer PC Access 3.  This is...
See more
Back
Top