Recent content by bobgto65

I purchased a Sandman Ring Voltage Booster II on eBay. This is connected to the line in from my Verizon Fios ONT box and creates a true sine wave 90V ring voltage on the line out that runs to the controller board. After cionnecting it, I was finally able able to use the remote dial-in access to...

Yes, I see that on page 44 but the feature that I want is for the audio board to announce the alarm type over my HAI wall mounted speaker so the entire house can hear ir and that is not supported or mentioned in the installation mnaual.

I already have one in my Omni LT, but it does not work for the Omni LTE because the The Omni LTe lacks the necessary circuitry to support the 2-Way Voice Module. I bought an Omni LTE on eBay but I am likely to resell it and buy an OP2 due to this issue

The Omni LTE does not support 2 way audio. It is my understanding that the circuitry on the controller board for this feature was not included. The Module may be used with Omni LT, Omni, Omni II, Omni IIe, OmniPro and OmniPro II automation controllers. HAI Part Number: 10A11-1. This is on ,y...

I bought an Omni LTe board for the ethernet connectivity but now I see that it does not include audio capabilities so except for the tone on the console, there is no sound in the house if the alarm is tripped. My Omni LT had a separate audio board connected to a speaker that can be heard...

Thanks Pete, I know the LTe board is newer. I am going to give this some consideration. I willl post a follow-up next week. Thanks, Bob

Hi Pete, Thanks for your reply. My plan is to connect an ethernet cable to my router and use a Latronix UDS1100 listening in on Port 4369 with a static IP. Then the DB-25 on the UDS1100 connects with adaptors rossing over pins 2 and 3 to the RJ-11 port at the top left of the omniLT board. The...

Thank you for this information. I also found this out thanks to Chat Gpt.

Thank you for the advice.

No ethernet on th eOmni LT. I have not messed with the phone lines but the waveform and ring voltage put out by the FIOS ONT box may not be sufficient to wake up the HAI system. There are modifiers and voltage amplifiers that can address this but they are hot or miss. I think I will try the...

Note: My OmniLT does not support the AES encrypted Omni-Link Protocol. Is that why these apps do not work? ChatGPT states if I can find an old HAI snaplink version 1.6 APK I can user that and it will work but I can't find it on the web.

I am a new member of the group. I own an OmniLT system V 2.14 since Feb 2007. Recently, FIOS upgraded my ONT box to the latest version and now the system will not pick up outside calls for remote access. (Ring once or twice, hang up, wait 10-20 seconds, ring again). The remote access was fine...